In order to perform USB 2. The USB 2. You may download instructions for performing high-speed electrical tests on downstream ports of embedded hosts. Matlab Cable source code can be downloaded here. Email ssusbcompliance usb. Please note the equipment list is expected to change periodically as equipment models are discontinued or reach end of life. USB-IF testing must be done on one of these systems:. The following compliance devices are used in conjunction with compliance software to demonstrate USB hub or host compliance.
These devices are not designed for use with the windows stack, and are only to be used with host and hub specific tests. Please address host or hub testing questions to usbcompliance. This is a bus-powered device. The firmware updating utility can be downloaded here or directly from Microsoft. Contact usbcompliance usb.
USB 3. The Total Phase Advanced Cable Tester v2 is an all-in-one solution for rapidly ensuring your cables meet design specifications. This tool is intended for factory production testing and may additionally be used for pre-scan testing.
The VIDs included on this list have been obsoleted and are not valid. Search this site. Compliance Tools. Wilder Controller Visit www. Please wait until it loads completely. Paste the full contents into a text file named usbif. Note this is not a requirement of the official USB specification, rather a convention adopted by some PC makers. You should also look for the logo on USB 3.
Figure 5 shows the USB 3. Next, confirm that Windows enumerated the host controller as a USB 3. To confirm that, open Device Manager and locate the controller under the Universal Serial Bus controllers node. If Windows recognized it as a USB 3.
To indicate whether the USB 3. Don't miss out on the opportunity! If you have any questions about the certified USB logos, send them to admin usb. Search this site. Logo Usage Guidelines 7.
0コメント